Table of Contents
Advertisement
1 0 . M a i n t e n a n c e a n d S e r v i c e
1 0 . 1 : R o u t i n e M a i n t e n a n c e P r o c e d u r e s
Recorder Paper Installation
The recorder uses rolls of blank 50mm thermal-sensitive paper. See Section 10.3 for
ordering information.
1. Verify that the strip chart recorder is off.
2. Follow the paper loading instructions listed below.
• Push the latch at the top of the recorder to open paper compartment. Gently
remove the old roll.
• Place the new roll of recorder paper in the compartment. The paper should feed
out from under the bottom of the roll. Feed some paper out toward the front
across the rubber roller.
• Close the door.
3. Press the ON/OFF control key to obtain a recording. You should see lines and print
on the paper. Press the ON/OFF control key again to stop recording.
Note: If waveforms are not printed, the paper has been inserted backwards.
Repeat step 2, reversing the direction of the paper roll.
Recorder Paper Installation
10-8
Figure 10.3: Strip Chart Recorder
Advertisement
Table of Contents
Troubleshooting
