Autocat ® 2 Series Control Module - Arrow AutoCAT 2 Series Operating Manual

3 . P r i n c i p l e s o f O p e r a t i o n
3 . 1 : O v e r v i e w o f t h e A u t o C A T
AutoCAT ® 2 Series Control Module
The AutoCAT ® 2 Series has a detachable control/display module, housing the LCD that
shows all of the information you will monitor during pump operation and the function
control keypad. The control/display module is mounted on a bracket and connected to
the pneumatic drive module by a twelve foot (3.6m) cord. The control module can be
fully rotated 360°, with the base, raised upright to any position desired, or detached for
placement on an IV pole display mount.
To rotate or change the viewing angle of the control module:
1. Press the silver button located on the rear of the pneumatic unit. The screen will
rotate to any position and/or may be locked in 4 positions (90 degree intervals).
To raise or lower the control module:
1. To raise the control module press the blue button on the control module handle.
Raise the display to the desired height. Release the button to lock control head at
desired height.
2. To lower control module press the blue button and push the handle down to desired
position. Release button to lock.
To detach/attach the control module from the IABP drive module:
1. Reach behind the control module to the central section.
2. Squeeze the dark blue handle.
3. Lift the module straight up to clear the mounting bracket.
4. To reattach control module, place it over the locating pins and push down until a
click is heard, indicating it is locked in place.
To tilt the control module up or down:
1. Move the control module to the desired position by pushing or pulling it.
2. If the control module moves when keys are pressed, you can tighten the adjustment
by turning the knob on the lower right side of the display.
To allow for viewing of the LCD during transport, position the control module so that it
lays flat and face up in the well on top of the AutoCAT
Figure 3.2: The AutoCAT
To place the control/display module on the IV Pole Display Mount:
1. Detach the control module from the IABP drive module.
2. Slide the control/display module down over the mounting bracket on the IV Pole Mount.
3. The control/display module is secure when a click is felt.
AutoCAT ® 2 Series Control Module
3-6
® 2 S e r i e s
® 2 Series.
® 2 Series LCD and Control Function Keypad