Series Technical Specifications - Arrow AutoCAT 2 Series Operating Manual

1 1 . P e r f o r m a n c e a n d T e c h n i c a l S p e c i f i c a t i o n s
1 1 . 1 : A u t o C A T 2 S e r i e s S p e c i f i c a t i o n s
®
AutoCAT
Dimensions
Weight
Power
Requirements
Fuses
Battery Run Time
Assist Ratios
Environmental
Specification
Altitude
Pumping Rate
Lead Selection
Operation Modes
Technical Specifications
11-4
®

2 Series Technical Specifications

Monitor/Control Module:
9.25" high x 13.75" wide x 2.0" deep (23.5cm x 35.0cm x 5.0cm)
Pneumatic Drive Module:
28.0" high x 12.0" wide x 20.0" deep (71.0cm x 30.5cm x 51.0cm)
Monitor/Control Module: 6 lb. (2.7 kg.)
Pneumatic Drive Module: 80 lb. (36.3kg.)
90-264 VAC 47-63Hz
Average power consumption: 225 watts
Maximum power consumption: 420 watts (surge)
5 amp slo-blo
90 minutes (approximate, with full charge, 40 cc, 80 BPM,
Assist Ratio 1:1)
Optional 180 minutes with additional battery
1:1, 1:2, 1:4, 1:8
Operating Temperature: 5°C to 45°C (without Fiber Optic Sensor)
5°C to 35°C (with Fiber Optic Sensor)
Storage and transport Temperature: -15°C to 50°C
Storage and transport Atmospheric Pressure: 200 hPa - 1060 hPa
10,000 Ft. (5030M) with FiberOptix
40-200 BPM
ECG patient cable input: I, II, III, AVR, AVL, AVF,
and V with 5 lead cable.
From remote monitor: Phone-to-Phone
AutoPilot ™ :
Automatically selects ECG/AP signal, sources, trigger mode
and timing method and settings
Automatically changes settings to optimize assist.
Operator:
Allows user control of most pump functions
(150mmHg - 796mmHg)
™ sensor