Pin Definitions For The Scan Interface; Scan Interface - Teledyne T3MIL50 User Manual

Pin Definitions for the SCAN Interface

As this interface is used for the handler and scan functions, the interface
pinout depends on the function mode. The following pinout is only applicable
when using the Scan function.

Scan Interface

Pin
1,9-13,15-17,21,23
-25
2
3,14,18
4
5
6
7
8
19
20
22
78
HANDLER / SCAN / EXT I/O
13
25
Name Description
Reserved
Trigger Start for Scan measurement.
GND Ground.
High High signal. Indicates a HI compare
result.
Clock The clock signal will pulse high when
each group of output signals (Relay,
Pass, Low, High) are ready. There are
up to 100 groups of output signals.
Low Low signal. Indicates a LO compare
result.
Pass Pass signal. Indicates an IN compare
result (pass).
VINT Internal DC Voltage +5V.
VEXT External DC Voltage, acceptable
range is +5V.
Relay Controls the relay output.
STRB After all (up to 100) output groups
are ready, the STRB signal will pulse
high.
T3MIL Series User Manual
1
14
In/Out
In
Out
Out
Out
Out
Out
In
Out
Out