Rs232/Usb Function Check - Teledyne T3MIL50 User Manual

1. Select the RS-232
baud rate
RS-232 pin
assignment
PC – T3MIL
RS-232C
connection

RS232/USB Function Check

Operation
Note
86
Configure the interface to RS232 and
set the baud rate in
System>Utility>Interface menu.
Connect the RS-232C cable to the rear
panel RS232 port.
Pin 2: RxD
Pin 3: TxD
Pin 5: GND
Pin 1, 4, 6 ~ 9: No Connection
The RS232C connection uses a Null-modem connection,
in which transmit (TxD) and receive (RxD) lines are
cross-linked.
T3MIL
Pin2 RxD
Pin3 TxD
Pin5 GND
Invoke a terminal application such as Realterm.
For RS-232, set the COM port, baud rate, stop bit, data
bit and parity accordingly.
To check the COM settings in Windows, see the Device
Manager. For example, in WinXP go to the Control panel
→ System → Hardware tab.
Run this query from the terminal.
*idn?
This should return the Manufacturer, Model number,
Serial number, and Firmware version.
Teledyne, T3MIL50X, TXXXXXXXX, V1.00
If you are not familiar with using a terminal application to
send/receive remote commands from the serial port or
via a USB connection, please page 87 (Using Realterm to
Establish a Remote Connection) for more information.
T3MIL Series User Manual
Page 64
PC
RxD Pin2
TxD Pin3
GND Pin5
RS232
1 5
6 9