Safety Guidelines - Teledyne T3MIL50 User Manual

Safety Guidelines

General Guideline
CAUTION
Power Supply
WARNING
Cleaning the
T3MIL50/50X
Operation
Environment
6
Do not place any heavy objects on the instrument.

Avoid severe impact or rough handling that leads to

damaging the instrument.
Do not discharge static electricity to the instrument.

Use only mating connectors, not bare wires, for the

terminals.
Do not disassemble the instrument unless you are

qualified as service personnel.
(Note) EN 61010-1:2010 specifies the measurement categories and
their requirements as follows. The T3MIL50/50X doesn't fall
under category II, III or IV.
Measurement category IV is for measurements performed at the

source of low-voltage installation.
Measurement category III is for measurements performed in the

building installation.
Measurement category II is for measurements performed on the

circuits directly connected to the low voltage installation.
AC Input voltage: 100 - 240 V AC, 50 - 60Hz, 25VA

The power supply voltage should not fluctuate more

than 10%.
Connect the protective grounding conductor of the AC

power cord to an earth ground, to avoid electrical
shock.
Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild

detergent and water. Do not spray any liquid into the
instrument.
Do not use chemicals or cleaners containing harsh

material such as benzene, toluene, xylene, and acetone.
Location: Indoor, no direct sunlight, dust free, almost

non-conductive pollution (Note below)
Temperature Range: 0~35°C, Relative Humidity:

<80%RH; >35°C, Relative Humidity: <70%RH
Altitude: < 2000m

Operating Environment: 0°C to 40°C (operation)

Pollution Degree 2

T3MIL Series User Manual