Pin Definitions For The Handler Interface; Handler Interface For Binning And Compare Functions - Teledyne T3MIL50 User Manual

Pin Definitions for the Handler Interface

As this interface is used for the handler and scan functions, the interface
pinout depends on the function mode. The following pinout is only applicable
when using the Binning or Compare function.

Handler Interface for Binning and Compare Functions

Pin Name
1, 17
Trigger
2
GND
3, 14,
18
Fail
4
High
5
Pass
6
EOT
7
VINT
8
Bin1
9
Bin2
10
Bin3
11
Bin4
12
Bin5
13
HANDLER / SCAN / EXT I/O
13
25
Description
Reserved
Trigger for a single measurement.
Ground.
High when the compare result is
either HI or LO (fail).
High when the compare result is
deemed HI.
High when the compare result is IN
(pass).
High when the AD conversion has
completed. The DUT is ready to be
changed.
Internal DC Voltage +5V.
High when the binning sorting result
is within the bin1 setting range.
High when the binning sorting result
is within the bin2 setting range.
High when the binning sorting result
is within the bin3 setting range.
High when the binning sorting result
is within the bin4 setting range.
High when the binning sorting result
is within the bin5 setting range.
HANDLER/SCAN INTERFACE
1
14
Active
modes
All
Compare Out
Compare Out
Compare Out
Ext
trigger
mode
Binning
Binning
Binning
Binning
Binning
In/
Out
In
Out
Out
Out
Out
Out
Out
Out
75