Safety Compliance; Environmental Compliance - Teledyne T3MIL50 User Manual

Safety Compliance

EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The instrument meets intent of EC Directive 2014/35/EU for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use –
Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use –
Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:
Mains Supply Connector: Overvoltage Category II, instrument
•
intended to be supplied from the building wiring at utilization points
(socket outlets and similar).
Measuring Circuit Terminals: No rated measurement category.
•
Terminals not intended to be connected directly to the mains supply.
Unit: Pollution Degree 2, operating environment where normally only dry,
•
non-conductive pollution occurs. Temporary conductivity caused by
condensation should be expected.

Environmental Compliance

END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it
complies with the applicable European Union requirements of
Directives 2012/19/EU and 2006/66/EC on Waste Electrical
and Electronic Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that vary by
country and region. Many countries prohibit the disposal of waste electronic
equipment in standard waste receptacles. For more information about proper
disposal and recycling of your Teledyne LeCroy product, please visit
teledynelecroy.com/recycle.
CERTIFICATIONS
151