Handler Mode - Teledyne T3MIL50 User Manual

Note

Handler Mode

Background
User Define 1/2: Pin Active: High, Low
The Bin logic settings are not available for the T3MIL50.
Pressing ESC before pressing ENTER will exit from the
selected External I/O setting.
The Handler Mode setting determines the behavior of
the result signals from the handler interface. There are
two settings, Clear and Hold. The Clear setting will clear
the results of the previous test before starting the
succeeding one and the Hold setting will keep the test
result of the previous test until the succeeding test has
completed.
The timing diagrams below are used as examples. All the
result signals in the examples are active high.
Logic:
Operand1 Operator Operand2
Fail
Pass
Logical OR,
Low
High
Bin O**
Bin 1 ~ 8
*The OFF operator sets the Logic as
true when Operand1 is true.
** Bin O is defined as outside bin 1~ 8.
MEASUREMENT
Fail
Pass
Low
Logical
AND,
High
OFF*
Bin O**
Bin 1 ~ 8
67