Polaris RANGER 500 2018 Service Manual page 434

Hide thumbs Also See for RANGER 500 2018:

Table of Contents

10. Inspect the AWD coil

plate assembly. Refer to AWD Diagnosis, page 7.14

for detailed inspection process. Replace the cover

11. Remove the roll cage assembly and rollers from the

clutch housing. Use a shop towel to cover the

housing in order to retain all the rollers.

Rollers are spring loaded. Take care not to allow them

to fall out or lose them upon removal of the roll cage.

12. Thoroughly clean all parts and inspect the rollers

for nicks and scratches. The rollers must slide up

and down and in and out freely within the roll cage

sliding surfaces and H-springs.

Refer to the "Electronic Parts Catalog" for individual

part availability. Most parts are to be replaced as an

assembly or as a complete kit.

13. Inspect clutch housing / ring gear

wear pattern. Inspect the ring gear for chipped,

broken, or missing teeth.

located in the outer cover

for a consistent

14. Inspect the roll cage assembly

and H-springs

and free of nicks, burrs or scratches. If damaged,

replace the roll cage assembly.

15. Inspect both output hub assemblies. Inspect the

bearings and replace if needed.

16. Clean and inspect all remaining front gearcase

components. Check each for excessive wear or

9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual

sliding surfaces

. The sliding surfaces must be clean

Roller Surface

Thrust Bearing

Chapters

Table of Contents