Stator / Stator Cover Installation - Polaris RANGER 500 2018 Service Manual

ENGINE / COOLING SYSTEM

STATOR / STATOR COVER INSTALLATION

1. Clean and degrease stator screws and threads in the
stator housing.
2. Clean mounting surfaces of stator
3. Apply crankcase sealant to edges of rubber stator
grommet.
4. Set the stator in housing and press wire grommet
into slot on housing.
5. Apply Loctite® 242™ to end (8-10 threads) of the
e
stator screws and the wire routing bracket screws
r
.
6. Install a new stator cover gasket.
7. Install the stator cover.
CAUTION
The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the installation process or injury could
8. Install the stator cover screws and torque to
specification.
TORQUE
Stator Mounting Bolts:
9 ft-lbs (12 Nm)Apply Loctite® 242™
TORQUE
Stator Wire Retainer:
6 ft-lbs (9 Nm)
Apply Loctite® 242™
3.122
q
and housing
result.
w
.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.