Starter One-Way Clutch Installation; Flywheel Installation - Polaris RANGER 500 2018 Service Manual

ENGINE / COOLING SYSTEM

STARTER ONE-WAY CLUTCH INSTALLATION

1. Install one-way clutch in clutch hub with flange of
q
clutch facing the flywheel.
The one-way clutch can be installed into the hub
incorrectly. This will cause engine cranking issues.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Apply Loctite® 272™ on the one way clutch retaining
w
bolts threads . Place hub on flywheel and install
bolts.
4. Torque screws to specification.
TORQUE
One Way Clutch Retaining Bolts:
9 ft-lbs (12 Nm) Apply Loctite® 272™
3.120
NOTE

FLYWHEEL INSTALLATION

1. Clean the threads
crankshaft to remove all oil or grease.
2. Clean flywheel taper
or grease.
3. Apply a small amount of PS4 engine oil to the flat
t
area on the MAG side crankshaft. DO NOT apply
engine oil to the crankshaft taper.
4. Rotate crankshaft so the flywheel key
upward.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
q w
, taper and flat
r
with alcohol to remove all oil
y
is facing
© Copyright Polaris Industries Inc.
e
of