Oil Pump Removal - Polaris RANGER 500 2018 Service Manual

ENGINE / COOLING SYSTEM
4. Set the stator in housing and press wire grommet into
slot on housing.
5. Apply Loctite® 242™ to end (8-10 threads) of three
q
stator screws and the two wire routing bracket
w
screws .
6. Install all five screws and torque to specification.
TORQUE
Stator Cover Bolts
9 ft-lbs (12 Nm)Apply Loctite® 242™
TORQUE
Stator Wire Bracket Bolts
6 ft-lbs (9 Nm)Apply Loctite® 242™
7. Install a new stator cover gasket into the engine.
8. Install the stator cover as outlined in this chapter.
CAUTION
The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
3.92
result.

OIL PUMP REMOVAL

1. Remove the fasteners
(mag) portion of the crank case
section of the crank case.
2. Rotate the crankshaft to TDC position by aligning the
w
timing hole in crankcase with a timing hole in the
crankshaft. Insert a 1/4" drive socket extension
through the crankcase and into the crankshaft
locating hole.
3. Remove the oil pump sprocket bolts
Discard the bolts and replace with new for assembly.
Remove the sprockets and chain
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
q
retaining the intermediate
w
and remove this
e
and washers.
r
from the engine.
© Copyright Polaris Industries Inc.