Polaris RANGER 500 2018 Service Manual page 210

ENGINE / COOLING SYSTEM
REF. DESCRIPTION
q Cylinder
w Cylinder Base Gasket
e Piston Assembly
r O-ring
t Straight Filter Adapter
y Oil Filter
u Screw
i Plug
o Drain Plug
a Screw
s Screw
d Gear
f Gear
g Screw
h Oil Pump Cover
j Gerotor Outer
k Gerotor Inner
3.132
NOTES
Apply ENGINE OIL to bottom 50 mm of cylinder bore and to piston
rings before assembly.
Ensure tab is visible to verify assembly.
Apply ENGINE OIL to bottom 50 mm of cylinder bore and to piston
rings before assembly.
Ensure O-ring seals are seated in C'bores before assembly.
Torque: 20 ft-lbs (28 Nm)
Lubricate seal with engine oil prior to filter installation.
Torque: 20 ft-lbs (28 Nm)
Torque: 11 ft-lbs (16 Nm)
Torque: 11 ft-lbs (16 Nm)
Torque: 106 in-lbs (12 Nm)
Torque: 106 in-lbs (12 Nm)
Sprockets to be installed so that "OUT" is visible.
Torque: (12 Nm)
Replace if loosened or removed.
Apply ENGINE OIL to bore of oil pump cover prior to assembly.
Gerotor dots must not be visible after assembly.
Gerotor Slot must be visible after assembly
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.