Master Cylinder; Removal; Installation - Polaris RANGER 500 2018 Service Manual

BRAKE SYSTEM

MASTER CYLINDER

REMOVAL

1. Remove the retaining clip
that attaches the master cylinder to the brake pedal
lever.
2. Remove LH wheel well panel to access master
cylinder.
3. Remove the two mounting bolts
master cylinder to the frame.
9.8
q w
from the clevis pin
e
that secure the
4. Remove master cylinder and place a fluid catch
container under the master cylinder brake line banjo
r
bolt .
REF. DESCRIPTION
e Mounting Bolts
r Banjo Bolts
CAUTION
Brake fluid will damage finished surfaces.
Do not allow brake fluid to come in contact with finished
surfaces.
5. Loosen the brake line banjo bolts
fluid to drain.
Make note of front and rear brake line orientation on the
master cylinder.
6. Dispose of brake fluid properly and do not re-use.

INSTALLATION

Reverse Steps 1-5 for master cylinder installation. Refer
to the torque specifications in the illustration.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
NOTES
Torque to 15 ft-lbs
(20 Nm)
Torque to 15 ft-lbs
(20 Nm)
r
and allow the
NOTE
© Copyright Polaris Industries Inc.