Spider Removal - Polaris RANGER 500 2018 Service Manual

Hide thumbs Also See for RANGER 500 2018:

Table of Contents

SPIDER REMOVAL

1. Install clutch in holding fixture

(counterclockwise) using

Removal Tool

Clutch Holding Fixture:

PN 2871358-A

Spider Removal Tool:

It is important that the same number and thickness of

washers are reinstalled beneath the spider during

assembly. Be sure to note the number and thickness of

these washers.

9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual

Moveable Sheave Bushing Inspection

and loosen the

2. Inspect the Teflon™ coating on the moveable sheave

Replace the cover bushing if more brass than Teflon is

visible on the bushing. Refer to bushing replacement in

ROLLER, PIN, AND THRUST WASHER

1. Inspect all rollers, bushings and roller pins by pulling

a flat metal rod across the roller. Turn roller with your

finger. If you notice resistance, galling, or flat spots,

replace rollers, pins and thrust washers in sets of

three. Also inspect to see if roller and bushing are

separating. Bushing must fit tightly in roller. Use the

Roller Pin Tool to replace rollers and pins. Take care

not to damage roller bushing or bearing surface of

the new pin during installation.

Moveable Sheave Bushing Inspection:

this chapter.

Roller Pin Tool:

Table of Contents