INVT Goodrive20-EU Series Operation Manual page 80

Goodrive20-EU Series VFD
Function
Name
code
Jog running
P08.06
frequency
Jogging
running
P08.07
acceleration
time
Jogging
running
P08.08
deceleration
time
Jumping
P08.09
frequency 1
Jumping
P08.10 frequency
range 1
Jumping
P08.11
frequency 2
Jumping
P08.12 frequency
range 2
Jumping
P08.13
frequency 3
Jumping
P08.14 frequency
range 3
P08.15 Traverse range This function applies to the industries where
Sudden
jumping
P08.16
frequency
range
Traverse boost
P08.17
time
This parameter is used to define the reference
frequency during jogging.
Setting range: 0.00Hz–P00.03 (the max.
frequency)
The jogging acceleration time means the time
needed if the VFD runs from 0Hz to the max.
frequency.
The jogging deceleration time means the time
needed if the VFD goes from the max. frequency
(P00.03) to 0Hz.
Setting range: 0.0–3600.0s
When the set frequency is in the range of
jumping frequency, the VFD will run at the edge
of the jumping frequency.
The VFD can avoid the mechanical resonance
point by setting the jumping frequency. The VFD
can set three jumping frequency. But this
function will be invalid if all jumping points are 0.
Set frequency f
Jump
frequency 3
Jump
frequency 2
Jump
frequency 1
Setting range: 0.00–P00.03 (the max. frequency)
traverse and convolution function are required
such as textile and chemical fiber.
The traverse function means that the output
frequency of the VFD is fluctuated with the set
frequency as its center. The route of the running
frequency is illustrated as below, of which the
Description
frequency range 3
frequency range 3
1/2*Jump
frequency range 2
1/2*Jump
frequency range 2
1/2*Jump
frequency range 1
1/2*Jump
frequency range 1
Time t
-75-
Function parameters
Default Modify
5.00Hz
Depend
on
model
0.00Hz
0.00Hz
0.00Hz
1/2*Jump
0.00Hz
1/2*Jump
0.00Hz
0.00Hz
0.0%
0.0%
5.0s
○
○
○
○
○
○
○
○
○
○
○
○