INVT Goodrive20-EU Series Operation Manual page 34

Goodrive20-EU Series VFD
No. Name
4 Buttons
Analog
5 potential
meter
Keypad
6
port
S
S
v
v
Programm
PRG
ESC
ing key
DATA
Entry key
ENT
UP key
DOWN
key
Right-shift
SHIFT
key
Run key
RUN
Stop/
STOP
RST
Reset key
QUICK
Quick key
JOG
AI1, When the external common keypad (without the function of
parameter copy ) is valid, the difference between the local keypad AI1 and
the external keypad AI1 is:
When the external keypad AI1 is set to the Min. value, the local keypad
AI1 will be valid and P17.19 will be the voltage of the local keypad AI1;
otherwise, the external keypad AI1 will be valid and P17.19 will be the
voltage of the external keypad AI1.
Note: If the external keypad AI1 is frequency reference source, adjust the
local potentiometer AI1 to 0V/0mA before starting the VFD.
External keypad port. When the external keypad with the function of
parameter copying is valid, the local keypad LED is off; When the external
keypad without the function of parameter copying is valid, the local and
external keypad LEDs are on.
Description
t
.
Enter or escape from the first level menu and
remove the parameter quickly
Enter the menu step-by-step
Confirm parameters
Increase data or function code progressively
Decrease data or function code progressively
Move right to select the displaying parameter
circularly in stopping and running mode.
Select the parameter modifying digit during the
parameter modification
This key is used to operate on the VFD in key
operation mode
This key is used to stop in running state and it is
limited by function code P07.04.
This key is used to reset all control modes in the
fault alarm state
The function of this key is confirmed by function
code P07.02.
-29-
Keypad operation
U
t
-
.
U
-