Emerson Rosemount 2230 Reference Manual page 35

Reference Manual
00809-0100-2230
Ensure that:
• the power supply is able to provide the total current needed for all the connected
devices.
• the Rosemount 2230 and other devices connected to the F
system are compliant with the FISCO or Entity parameters of the power supply.
• the short circuit protection of the Segment Coupler
consumption of the connected devices.
Related information
Product certifications
Power requirements
3.4.9 Wiring
Use the following wiring procedure for the Rosemount 2230:
Prerequisites
Note
Ensure that o-rings and seats are in good condition prior to mounting the cover in order to
maintain the specified level of ingress protection. The same requirements apply for cable
inlets and outlets (or plugs). Cables must be properly attached to the cable glands.
Procedure
1. Unscrew and remove all screws at the front of the display.
2. Remove the cover carefully. Take care of the locking spring for the weather
3. Run the Tankbus cable through the gland.
4. Connect the Tankbus wires to the X2 and X3 terminals.
5. Connect the cable shield to the "Shield Loop Through" (X1) terminal.
6. If the Rosemount 2230 display is the last device on the Tankbus, connect a jumper
7. Replace the cover. Make sure that the sealing and the locking device for the
8. Firmly tighten the screws on the front cover.
(9) See the Rosemount 2410
Coupler.
Rosemount 2230 Graphical Field Display
protection hatch.
Note
Do not disconnect the cables between the display front and the circuit board.
Ensure that the compartment is protected against water in case of rain.
Ensure that the positive lead is connected to the terminal marked FB+ and the
negative lead to the terminal marked FB-.
for the built-in termination.
weather protection hatch are placed in the correct positions.
Reference Manual (Document No. 00809-0100-2410) for more information on the Segment
Installation
March 2021
Fieldbus (FF)
OUNDATION
(9)
matches the current
35