Register Transducer Block Parameters - Emerson Rosemount 2230 Reference Manual

Reference Manual
00809-0100-2230
Table C-2: FD_SIMULATE elements
Index Parameter
1 Diagnostic Simulate
Value
2 Diagnostic Value
3 Enable
C.2

Register Transducer block parameters

The Register Transducer Block (TB 1200) allows access to Database registers and Input
registers of the Rosemount 2230 Graphical Field Display. This makes it possible to read a
selected set of registers directly by accessing the memory location.
The Register Transducer block is only available with advanced service.
CAUTION
Since the Register Transducer block allows access to most registers, it should be handled
with care and ONLY to be changed by trained and certified service personnel, or as guided
by Emerson Automation Solutions support personnel.
Table C-3: Register Transducer Block Parameters
Index Parameter
Number
1 ST_REV
2 TAG_DESC
3 STRATEGY
4 ALERT_KEY
5 MODE_BLK
6 BLOCK_ERR
7 UPDATE_EVT
8 BLOCK_ALM
Rosemount 2230 Graphical Field Display
Data Type Size Description
Bit string 4 Writable. Used for diagnostics when simulation is
enabled
Bit string 4 Current diagnostics detected by the device.
Unsigned 8 1 Enable/Disable simulation. Dynamic, so simulation will
always be disabled after a device restart.
Description
The revision level of the static data associated with the function
block. The revision value increments each time a static
parameter value in the block is changed.
The user description of the intended application of the block.
The strategy field can be used to identify grouping of blocks. This
data is not checked or processed by the block.
The identification number of the plant unit. This information may
be used in the host for sorting alarms, etc.
The actual, target, permitted, and normal modes of the block.
Target: The mode to "go to"
Actual: The mode the "block is currently in"
Permitted: Allowed modes that target may take on
Normal: Most common mode for target
This parameter reflects the error status associated with the
hardware or software components associated with a block. It is a
bit string, so that multiple errors may be shown.
This alert is generated by any change to the static data
The 2230 transducer block does not support update of
BLOCK_ALM information, and it does not publish BLOCK_ALM on
segment/FF bus.
™
F Fieldbus Block Information
OUNDATION
March 2021
163