Configure The As-Fcopm With Hwconfig - Delta AS Series Operation Manual

Hide thumbs Also See for AS Series:

Table of Contents

Send Quote Requests to info@automatedpt.com

10.2.3 Configure the AS-FCOPM with HWCONFIG

This section uses ISPSoft for demonstration. For DIADesigner operation, refer to Chapter 6 from DIADesigner

software manual.

Before using the AS-FCOPM card in an AS300 Series PLC, use HWCONFIG in ISPSoft to configure the AS-

FCOPM card. If you are using an AS100 or AS200 Series PLC, the first two steps can be ignored.

You can only install the AS-FCOPM in the card 2 slot as marked in red below. Double click the function

card 2 slot to go to the Device Setting dialog box.

Select Manual for Card 2 Detect mode and select AS-FCOPM Card for Manual Select Card.

Select the working mode, node ID and the bit rate for AS-FCOPM.

* Working mode: CANopen DS301

* Node ID: 1

* Bit rate: 125k bps (the default, or you can select your own bit rate)

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Show Quick Links

Table of Contents