Error Codes And Led Indicators For Module As00Scm As A Communication Module; Error Codes And Led Indicators For Module As00Scm As A Remote Module; Error Codes And Led Indicators For Module As01Dnet (Master/Slave Mode); Error Codes And Led Indicators For Module As00Scm As A Remote - Delta AS Series Operation Manual

Send Quote Requests to info@automatedpt.com
12.4.7 Error Codes and LED Indicators for Module AS00SCM as a
Communication Module
Error Code
16#1605
16#1606
16#1802
16#1803
16#1804
12.4.8 Error Codes and LED Indicators for Module AS00SCM as a
Remote Module
Error Code
16#1301
16#1302
16#1303
16#1304
16#1500
16#1502
16#1503
16#1505
16#1506
16#1604
12.4.9 Error Codes and LED Indicators for Module AS01DNET
(Master/Slave Mode)
Code
0~63
80
F0
F1
F2
Hardware failure
The setting of the function card is incorrect.
Incorrect parameters
Communication timeout
The setting of the UD Link is incorrect.
Hardware failure
The setting of the function card is incorrect.
24 VDC power supply is not sufficient and then is recovered
from a low-voltage less than 10ms situation.
More than eight remote modules on
the right side of the CPU module.
Remote module communication timeout
Incorrect parameters
Extension module communication timeout
The actual placement of the extension modules is NOT the
same as it is set.
Remote module had been stopped.
Extension module communication timeout
Explanation
Node address of AS01DNET-A
(in normal operation)
AS01DNET-A is in STOP status.
The node ID of AS01DNET is the
same as that of other node or
exceeds the allowed range.
No configured slave in Scan List.
Too low voltage of the work
power
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Description
Description
--
Turn the PLC to RUN and start I/O data exchange
1. Ensure that the node address of AS01DNET is unique.
2. Re-power AS01DNET.
Configure the scan list and then download the configuration to
AS01DNET.
Check if the power supply for AS01DNET and the PLC is normal.
ERROR LED indicator status
ON
V
V
ERROR LED indicator status
Blinking
ON Blinking
slow
V
V
V
V
V
V
V
V
V
Correction
Blinking
V
V
V
Blinking
fast
V