Daily Maintenance; Required Inspection Tools; Daily Inspection - Delta AS Series Operation Manual

Send Quote Requests to info@automatedpt.com

D.2 Daily Maintenance
To keep an AS series system operating normally, ensure that the ambient environment and the AS series system
conform to the cautions listed in section D.1. You can then perform the daily inspection described below. If you find any
problems, follow the solution and perform any necessary maintenance.
D.2.1 Required Inspection Tools

A screwdriver

Industrial alcohol

A clean cotton cloth
D.2.2 Daily Inspection
No.
1 Appearance
2 Installing of a backplane
3 Installing of a module
4 Connection
To prevent an unexpected shock from resulting in damage to the AS Series system and a
controlled element, ensure that the modules are correctly and firmly installed.
Item
Check visually.
Check whether the set
screws are loose.
Check whether the
backplane is installed on
the DIN rail properly.
Check whether the
module is loose that the
projection is inserted into
the hole on the backplane,
and that the screw is
tightened.
Check whether the
removable terminal block
is loose.
Check whether the
connector is loose.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Inspection
Dirt must not be
present.
The backplane must
be installed firmly.
The projection under
the module must be
inserted into the hole
in the backplane, and
the screw must be
tightened.
The removable
terminal block must
not be loose.
The connector must
not be loose.
Criterion Remedy
Remove the dirt.
Tighten the
screws.
Install the
backplane on the
DIN rail properly.
Install the module
firmly.
Install the terminal
block firmly.
Tighten the
screws on the
connector.