Procedure For Creating A Project In Ispsoft - Delta AS Series Operation Manual

Send Quote Requests to info@automatedpt.com

6.2 Procedure for Creating a Project in ISPSoft

This section shows you the procedure for creating a project in ISPSoft. You can adjust the procedure
according to your needs.
Hardware configuration

You set the parameters such as a range of latched devices and a port number in a PLC. You configure
the modules with an AS Series CPU module, and set the parameters in these modules.
Network configuration

If a system uses a network architecture, or devices need to exchange data, use the network configuration
tool NWCONFIG in ISPSoft to configure a network and exchange data with COM as well as Ethernet.
Programming

After you write a program in ISPSoft, compile the program. If the compiling is unsuccessful, messages in
the Compile Message page show where the errors occur.
Testing and debugging

Download the compiled program, the hardware configuration, and the network configuration to a PLC.
You can then test and debug the program online with the functions provided by ISPSoft.
Because the example introduced in this chapter does not discuss a network configuration, you only perform
the following procedure.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com