®
R&S
TSMA6
Figure 3-4: Connected R&S TSMA6/6B and R&S TSMA6-BP
1 = Attach R&S TSMA6 to R&S TSMA6-BP
2 = Move R&S TSMA6/6B to the rear side
3 = Power connection established (docking connector is snapped in)
3.1.8 Switching on or off R&S TSMA6
To switch on the device
The device is off but connected to power.
► Press the power on/off button.
The Pwr LED starts green blinking. After booting, the color changes to green resp.
blue continuous depending on the state of the WLAN access point (see
ter 3.2.5, "Status
To shut down the device
► Press the power on/off button.
The Pwr LED starts blinking green. The operating system shuts down and the Pwr
LED is switched off.
User Manual 4900.8057.02 ─ 11
LEDs",
on page 35).
Getting started
Preparing for use
Chap-
25