Restore Factory Backup - R&S TSMA6 User Manual

®
R&S TSMA6
Loss of user settings after restore
Executing restore brings the R&S TSMA6 irreversible back to the condition of delivery
or any other subsequently stored user backup version.
On the C:\ drive, all user settings and installed programs since the last backup will be
deleted.
The D:\ partition is deleted if enabled in the web-GUI, see
on page 168.
Table 10-2: Restore conditions
Initiate Restore /
Available Partitions
Factory Backup
User Backup (see
ter 10.1, "User
on page 122)
Condition after restore
Partition C:\
Partition D:\ (default)
Partition D:\
(web-GUI setting
Data partition D:"
on page 168)
When the restore procedure has been completed, the color of the [Mode] LED
depends on the state of the WLAN AP (see
Table 10-3: LED states (Restore)
[Mode] LED
blue blinking
green
blue

10.3 Restore factory backup

To restore the factory backup, perform the following steps.
1. Connect mouse, keyboard and monitor to the R&S TSMA6.
2. Press the [Shift] key and reboot the operating system.
3. The R&S TSMA6 reboots in the R&S recovery environment.
User Manual 4900.8057.02 ─ 11
Restore button
X
Chap- no user backup
backup",
(factory default)
C:\factory backup
unchanged
deleted
"Delete
Status
Restore process running
Restore process finished, WLAN AP off
Restore process finished, WLAN AP on
User backup and restore
Restore factory backup
"Delete Data partition D:"
Restore button Restore factory backup
(see
"Restore factory
backup",
X X
X X
C:\user backup C:\factory backup
unchanged unchanged
deleted deleted
Table 10-3).
Chapter 10.3,
on page 123)
123