Troubleshooting; Led Indicated Errors - R&S TSMA6 User Manual

®
R&S TSMA6

11 Troubleshooting

For all troubleshooting procedures, connect keyboard, mouse and a monitor to the
R&S TSMA6.
● LED indicated
● Evaluate selftest
● Access the firmware log
● Write battery info into firmware log
● Verify scanner link / recall device info using TSME Device
● R&S TSMA6 automatically switches off after power
● Scanner is not found from software (R&S ROMES, R&S
● Verify LAN settings (internal scanner
● No remote access via LAN
● WLAN access point not detected by external PC, mobile or
● Web GUI not accessible via WLAN
● Web GUI locally not
● Slow/Instable WLAN
●
Bluetooth
● No RF / GPS
● Contacting customer

11.1 LED indicated errors

●
"Mode" LED blue blinking fast − Selftest Error
-
-
●
"State" LED red blinking (2 Hz) − Temperature Warning
-
-
●
"State" LED red continuous − Overheated Unit
-
-
●
"Meas" LED red blinking (2 Hz) − Application Error
-
● "Pwr" LED off after startup − Power Error
-
User Manual 4900.8057.02 ─ 11
errors............................................................................................. 125
file.............................................................................................. 126
file.................................................................................. 126
accessible.............................................................................143
connection........................................................................... 145
®
device not detected by R&S
data................................................................................................. 147
support................................................................................ 148
Check the scanner connection (see
scanner connection)", on page 135).
Evaluate the Selftestresult.txt (see
file", on page 126).
Check the ventilation openings and the operating temperature.
Switch off the device and let it cool down.
Switch off the device and let it cool down.
Check the ventilation openings and switch on the device. If the problem occurs
again, analyze the Selftestresult.txt (see
test file", on page 126).
Refer to the application note of the used software.
Contact R&S support.
file.................................................................. 126
connection)................................................ 135
port............................................................................ 137
connection.................................................... 142
TSMA6...................................................145
Chapter 11.8, "Verify LAN settings (internal
Chapter 11.2, "Evaluate selftest
Troubleshooting

LED indicated errors

Manager................... 127
on........................................ 131
NESTOR).................... 132
tablet.......................140
Chapter 11.2, "Evaluate self-
125