®
R&S
TSMA6
Note: Do not switch off or unplug from power while running firmware/software
update.
11. Once the installation of all firmware/software packages has finished, the R&S
TSMA6 reboots.
After reboot the firmware is running a selftest (Mode LED is blinking green).
Note: If you are connected via WLAN, a reconnect to the R&S TSMA6 WLAN
access point may be necessary.
12. Open the web GUI. After a while, the status text in the web GUI changes to
No error.
The reboot is finished when the Mode LED changes into steady blue (WLAN AP
On) or green (WLAN AP Off) color.
13. Only for firmware installation.
If the firmware package contains a new mainboard firmware, a separate flash rou-
tine is started in a post process, see
ware
Note: If you are connected via WLAN, a reconnect to the R&S TSMA6 WLAN
access point may be necessary as the TSMAx reboots after the mainboard flash.
14. Reload the R&S TSMA6 web GUI (see
GUI",
view".
User Manual 4900.8057.02 ─ 11
Updating firmware/software/tools - general instructions
update",
on page 96.
on page 95) and verify the installed firmware /software version in the "Over-
Installing firmware and software updates
Chapter 8.3.5, "Subsequent steps after firm-
Chapter 8.3.4, "Calling R&S TSMA6 web
94