R&S Tsma6 Automatically Switches Off After Power On - R&S TSMA6 User Manual

®
R&S TSMA6
Label
Valid From
Valid To
Time to Expiration
Option Index
Format ID
11.6 R&S TSMA6 automatically switches off after power on
1. Check if there is a battery pack unit connected.
●
●
2. Check the state of charge of the batteries.
●
●
3. Perform one of the following actions.
a) Replace the batteries with fully charged ones and try again.
b) Charge the batteries in an external charger and retry later.
c) Connect DC supply to the R&S TSMA6 battery pack unit and charge the batter-
4. Connect DC supply to the R&S TSMA6 battery pack unit and check in the web GUI
the "Shutdown Settings".
Navigate to "Configuration" > "System" > "Power" and check the state of "Auto
Power Off".
●
●
User Manual 4900.8057.02 ─ 11
Description
Start of validity for temporary license
End of validity for temporary license
Time left until license expires
for internal use only
for internal use only
If yes, continue with step
If no, contact R&S support.
If the charging state is > 20% (charging indicator displays one loading bar),
continue with step 4.
If the charging state is < 20%, an auto power off of the device is performed due
to insufficient remaining battery charge. Continue with
ies inside the bay. Keep the R&S TSMA6 switched off.
If enabled, check the shutdown delay.
If not enabled, contact R&S support.
R&S TSMA6 automatically switches off after power on
2.
Troubleshooting
step 3
131