Built-In Gps Receiver; Built-In Wlan / Bluetooth Adapter - R&S TSMA6 User Manual

®
R&S TSMA6
●
Remote Control via Remote Desktop Connection
●
LAN interface in NESTOR Probe Mode
Table 3-1: LAN port LEDs
Status
Link status
Activity status
HDMI connector
See (16) in
Connecting an external monitor. (max. resolution: 2560 x 1600 pixel).

3.2.3 Built-In GPS receiver

The integrated multi-GNSS (GPS / BeiDou / Galileo / GLONASS) receiver allows to
use three satellite systems in parallel. It offers an accuracy improvement of 30 % to 50
% by using a second constellation of satellites.
Following combinations are allowed:
●
GPS only
●
GPS / GLONASS / Galileo
●
GPS / BeiDou
The R&S TSMA6 can perform dead reckoning in tunnels to provide position informa-
tion even if no satellites are available. The dead reckoning is performed by the device
with its built-in electronic gyroscopes.
For enabling untethered dead reckoning, see
dead
Depending on the intended use, the respective valid regulations regarding lightning
protection of the antennas and regarding vehicle installation must be observed during
installation.

3.2.4 Built-In WLAN / Bluetooth adapter

The R&S TSMA6 has built-in WLAN/Bluetooth module (Intel
The R&S TSMA6 WLAN / Bluetooth adapter allows the following modes.
●
Client connection to a distant WLAN network
●
Serving as a WLAN access point
Per default, the R&S TSMA6 WLAN access point is switched on. The login credentials
are found on the bottom label of the device. The WLAN / Bluetooth can be switched off
(flight mode) via rear panel switch.
User Manual 4900.8057.02 ─ 11
LED
yellow
green
Figure 3-7.
reckoning", on page 30.
Chapter 3.1.13, "Calibrating GPS for
®
Wireless AC 8265).
Getting started
Instrument tour
34