Status Leds - R&S TSMA6 User Manual

®
R&S TSMA6
Configure the WLAN and Bluetooth settings via web-GUI.
●
●
●

3.2.5 Status LEDs

The four LEDs on the rear panel display the following states.
●
●
●
Device
[Mode] LED [Meas] LED
Off Off
green (BLINKING, 1 ---
Hz)
green (CONT.) ---
blue (CONT.) ---
--- ---
--- ---
--- yellow (CONT.)
--- green (CONT.)
--- green (BLINKING, 0.5 Hz)
--- green/blue (BLINKING rapidly)
--- yellow (BLINKING, 2 Hz)
blue (BLINKING, 1 ---
Hz)
green (BLINKING, ---
0.2 Hz, ton = 1 s)
Error States
blue (BLINKING ---
rapidly)
User Manual 4900.8057.02 ─ 11
Chapter A.2.2.1, "Bluetooth",
Chapter A.2.2.2, "WLAN",
Chapter A.2.2.3, "WLAN
[Scanner State / Scanner Pwr]
Indicates the state of the scanner component
[Mode]
Indicates the device status
[Meas]
Indicates the state of the SW application
on page 160
on page 161
AP", on page 163
Scanner
[Pwr] LED [State]LED
Off Off
--- ---
--- ---
--- ---
green (BLINKING red (Off-On < 5s => Off )
rapidly => ON)
green (CONT.) ---
green (CONT.) green (BLINKING)
green (CONT.) green (CONT.)
green (CONT.) green (BLINKING)
green (CONT.) green (BLINKING)
--- ---
--- ---
--- ---
--- ---
Getting started
Instrument tour
Comment
Power Off
Power On Selftest /
Power Down
Power On / WLAN
Off
Power On / WLAN
On
Scanner configura-
tion ongoing
Scanner ready
SW loading
SW ready
SW measuring
SW recording
SW warning
Restore/
Backup/FW, SW
installation (in pro-
gress)
Delayed start activa-
ted
Selftest Failed/
Scanner Interface
not accessible
35