®
R&S
TSMA6
10 User backup and restore
10.1 User backup
The backup procedure takes up to 15 minutes.
During the backup, do not interrupt the procedure or disconnect the power supply.
To create a user backup, click the " Backup" button in the web GUI "(Backup"), see
"Backup TSMA6 System"
ated.
If there is an existing user backup, an acknowledgment dialog pops up. After confirma-
tion the user backup will be overwritten.
The status of the backup generation process is displayed via the [Mode] LED, see
Table
Table 10-1: LED states (Backup)
[Mode] LED
red blinking
green continuous
blue continuous
10.2 Restore
The Restore button brings the device back to factory / user default setting according to
Table
Use a blunt pen (diameter 1 to 2 mm) for pressing the Restore button.
Min. button hold time for restore trigger: 20 s.
The restore process is indicated by the [Mode] LED (see
The restore procedure takes up to 15 minutes.
During this time, do not interrupt the procedure or disconnect the power supply.
User Manual 4900.8057.02 ─ 11
on page 168. A backup of the system partition C:\ is cre-
10-1.
10-2.
Status
Backup process running
Backup process finished, WLAN AP off
Backup process finished, WLAN AP on
User backup and restore
Restore
Table
10-3).
122