®
R&S
TSMA6
All subsequent steps are similar to remote firmware installation, see
"Remote installation of the setup
8.6.3.4
Initial software start / measurement mode selection
After the successful installation of R&S SmartONE, the device always is in "QualiPoc"
mode.
Initial starting of SmartONE Expert (R&S ROMES)
1. Start the web GUI.
2. Navigate to "Configuration" > "System" > "Mode".
3. As "Mode of Operation" select "SmartONE Expert".
Make sure, that "Autostart" is deselected and no workspace is selected.
User Manual 4900.8057.02 ─ 11
Installing firmware and software updates
file",
on page 88,
step 5
Software update - details
Chapter 8.3.2,
and following.
111