Table of Contents
Advertisement
14
2 Safety Instructions
2.1 Intended Use
The product is a complete machine, intended for the following use:
•
For automated material transport in production with
◦
Operator-defined driving ranges
◦
Loading and unloading points
◦
Speeds in areas with pedestrian traffic.
•
For the transport of KLTs stacked on approved dollies with a total weight, incl. dolly, of up to 260 kg
and a max. stacking height of 1,200 mm.
•
For use with hand controllers.
•
The Charging Station is used exclusively for charging the ActiveShuttle 1.0. The product is strictly
intended for professional use and not for private use.
2.2 Improper Use
Any use other than that described in the section "Intended use" is considered improper and is not permitted.
Bosch Rexroth AG shall not be liable for any damage resulting from improper use. The user alone shall bear
any risks associated with improper use. The following foreseeable misuses also constitute improper use:
•
Transporting goods other than those specified.
•
Transporting people on the product or transported material.
•
Private use.
•
The Charging Station 1.0 must not be used as an elevated platform or climbing aid.
2.3 General safety instructions
•
As owner, note the following: before the initial start-up of the product, carry out a risk assessment in
accordance with the national regulations in your country (in Germany: according to the Occupational
Health and Safety Act).
•
Observe the applicable accident prevention and environmental protection regulations.
•
Observe the safety rules and regulations of the country in which the product is being used.
•
Only use Rexroth products that are in proper working order.
•
Heed all the warnings and notices on the product.
•
Persons who assemble, operate, disassemble, or maintain Rexroth products must not be under the
influence of alcohol, drugs, or medication that may affect their ability to react.
•
Use only original accessories and spare parts from Rexroth in order to prevent hazards to people due
to unsuitable spare parts.
•
Observe the technical data and ambient conditions specified in the product documentation.
•
Only commission the product if it has been determined that the end product (for example, a machine
or system) into which the Rexroth products have been installed, complies with national provisions,
safety regulations, and application standards.
2.4 Product-specific safety instructions
General
→ Do not attempt to modify the product.
→ Do not expose the product to any mechanical loads under any circumstances. Never use the product as
a handhold or step.
→ Do not place any objects on the product.
→ Always secure the product against tipping over.
During transport/assembly
RA91390962 AB-V1.3.3, en
ILS, ActiveShuttle | Safety Instructions
Advertisement
Chapters
Table of Contents
Troubleshooting
