Bosch rexroth ActiveShuttle System Manual page 111

Images/notes
RA91390962 AB-V1.3.3, en
Logistic commissioning | ILS, ActiveShuttle |
Course of action
4. Enter VMS port offset
Can be found in the docker-compose.yml file, in the
vms-section).
5. Enter the address of the map server.
6. Enter map server port offset
Can be found in the docker-compose.yml file, in the
vms-section).
7. Configure the remote data sync settings.
When checking the boxes, debug information can be
shared with the ActiveShuttle development team. This is
helpful for support, Wi-Fi traffic will increase and the
data is not encrypted.
8. Confirm the decision.
Now the ActiveShuttle will synchronize with the
NTP-server.
If needed, the default password can be
changed during the next start-up process of the RCU.
The message 'Clean up workspace?' appears.
9. Answer question with 'Yes'.
10. Restart the RCU.
11. Wait for the RCU to boot and change the password
to a personal password (if specified previously).
12. To check/change the settings which were entered
during the ActiveShuttle setup process, go to files (/
home/activeshuttle) and open the ams.config file.
The
activeshuttle.config
directory contains some information about the
ActiveShuttle itself, like RCU software version and more.
111
file found in the same