Displaying And Setting Rcf - Thermo Scientific Sorvall MTX 150 Instruction Manual

2
Note 1. Selecting the rotor is required to display and set an RCF value (see
RCF"
2. You can select your rotor in the Rotor Management screen, if you registered your rotor in
advance (see
3. Selecting the rotor is required when the rotor lockout function is enabled (see
(Admin) functions"

Displaying and setting RCF

This micro-ultracentrifuge stores the maximum and average radii of each rotor in the internal memory.
Setting a speed causes this micro-ultracentrifuge to automatically calculate and display the RCF
(relative centrifugal force) value, while setting an RCF value causes the micro-ultracentrifuge to
automatically calculate and display the speed. Given below is a description of how to display and set
RCF.
Process Touch panel operation
1 Press the PROGRAM button on the Run screen.
2 Press the column of the program name which you
want to delete. Then press the Delete button
after checking that the pressed column turns
blue.
2-38 Sorvall MTX 150
on page 2-38).
"Rotor Management"
on page 2-62
on page 2-49).
(3) "Rotor Lockout").
Screen display and notice
"Displaying and setting
"Administrator
PROGRAM button
• The PROGRAM screen
appears.
• The deletion
confirmation box is
displayed.
Thermo Scientific