Table of Contents
Advertisement
2
Process
Touch panel operation
4
Press the column of the desired program
name whose contents you want to check.
Then press the Select button after checking
that the pressed column turns blue.
Check the user name and rotor name in the
Program screen and decide whether this
selected program is the program that you
need or not.
If you think that the selected program is the
program you need, press the Edit button to
check the run parameters.
If you do not think that the selected
program is the program you need, press the
x button to switch to the previous screen.
After checking the run parameters, press
the Run button if the selected program is
the program you need.
STEP: 1-3
In this case, this program has three steps.
In the Run screen, the run parameters for
the first step in this program are displayed.
5
Run the micro-ultracentrifuge under normal
operation without making changes to the
run parameters.
2-28
Sorvall MTX 150
Screen display and notice
T h e r m o
Run button
Program name
• Run this micro-ultracentrifuge according to
page
2-11.
• If you make changes to the run parameters (such as SPEED and TIME)
after calling a program, the program you have just called is canceled. You
must call it again to use it.
Select button
Edit button
• The program name is
displayed on the PROGRAM
button indicator.
• If the "STEP:1-3" is
displayed on the PROGRAM
button indicator, this means
that the program you have just
called stores multiple run
parameters (step-mode
feature). For details, see
"Step-mode operation"
page
2-30.
"Operational procedure"
on
on
Thermo Scientific
Advertisement
Table of Contents
