Table of Contents
Advertisement
2
Process
Touch panel operation
4
Press the column of the desired program
name and press the Run button after
checking that the pressed column turns blue.
STEP: 1-3
In this case, this program contains three
steps.
In the Run screen, the run parameters for the
first step in this program are displayed.
5
Run the micro-ultracentrifuge under normal
operation without making changes to the
run parameters.
(b) If you do not know the program name you need.
Process
Touch panel operation
1
Turn on the POWER switch on the
micro-ultracentrifuge.
2
Install a rotor.
2-26
Sorvall MTX 150
Screen display and notice
Run button
Program name
• The program name is displayed on the PROGRAM button indicator.
• If the "STEP:1-3" is displayed on the PROGRAM button indicator, this
means that the program you have just called stores multiple run
parameters (step-mode feature). For details, see
page
2-30.
• Run this micro-ultracentrifuge according to
page
2-11.
• If you make changes to the run parameters (such as SPEED and TIME) after
calling a program, the program you have just called is canceled. You must call
it again to use it.
Screen display and notice
• Touchscreen appears.
• The door unlocks.
• Install the rotor securely on the shaft. (The rotor does not have to be
screwed into the shaft.)
• Always use a quick setting rotor (see
"Step-mode operation"
"Operational procedure"
"Applicable rotors"
on
page
2-4.)
Thermo Scientific
on
on
Advertisement
Table of Contents
