Epson SC-F2000 Service Manual page 258

SC-F2000
5. Set the height of the PLATEN to "P", and secure it with the Fixing Lever.
6. Click [RUN]. The TABLE ASSY is moved inside the printer.
7. Place the 1.55 thickness gauge in the middle of the home side of the PLATEN.
Figure 4-59. Set position of the thickness gauge on the home side
8. Confirm both Green LED and Orange LED of the sensor light.
9. Attach the adjustment screw.
10. Check the color of the LEDs, rotate the adjustment screw on the home side
clockwise to move the sensor position upward.
Adjust the sensor position up to when the LEDs change from "Green & Orange" to
"Green".
C H E C K
The lighting status of the LEDs changes in the order of "Green &
P O I N T
Orange" => "Orange" => "OFF" => "Green".
ADJUSTMENT
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
Thickness gauge
11. Remove the 1.55 thickness gauge, then place the 1.88 gauge.
12. Confirm both Green LED and Orange LED of the sensor light.
13. Tighten the two screws loosened in
14. Place the 1.55 thickness gauge in the middle of the home side of the PLATEN.
TF Adjustments
Adjustment screw
LED
Figure 4-60. The LEDs and adjustment screw on the home side
Step 2 on the home side.
Revision C
Green Orange
258
Confidential