Tf Adjustments; Pulley And Tf Belt Position Adjustment - Epson SC-F2000 Service Manual

SC-F2000

4.13 TF Adjustments

4.13.1 Pulley and TF Belt Position Adjustment

EXECUTION MODE
Normal Mode
STANDARD VALUE
4 to 5 mm
PROCEDURE
1. Disassemble the printer until you can access the TF belt.
2. Turn the printer ON.
3. Start the Service Program and select
4. Click [RUN].
The TABLE ASSY moves back and forth three times, then stops in the rear
position.
5. Check the TF belt position, and if the gap on the left is within the standard, no
adjustment is necessary. Otherwise, perform the adjustment as follows.
ADJUSTMENT
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
[Pulley and TF belt position Adjustment].
Measure this gap
TF Adjustments
TF belt
Figure 4-52. TF belt position check
Revision C
251
Confidential