Epson SC-F2000 Service Manual page 252

SC-F2000
6. Loosen the screw that secures the driven pulley.
7. Rotate the adjustment screw to adjust the tilt of the driven pulley.

To make the gap wider: Rotate the adjustment screw counterclockwise.

To make the gap narrower: Rotate the adjustment screw clockwise.
8. After the adjustment is done, tighten the screw loosened in
9. Go back to Step 4 and check again, then if it is within the standard, the adjustment
is completed.
Adjustment screw
Figure 4-53. TF belt position adjustment
C H E C K To move the TABLE ASSY back to the home position after the
P O I N T
adjustment, press [OK].
ADJUSTMENT
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
Step 6.
Driven pulley
Fixing screw
TF Adjustments
Revision C
252
Confidential