Epson SC-F2000 Service Manual page 24

SC-F2000
Menu Set up Item/level (shaded area: default setting)
Replace White Ink
Maintenance
Prolonged Storage
Head Alignment
Offset Head Alignment
Printer Setup
Feed Adjustment
Power On Cleaning*
Print Job Log Sheet
Print Logs
Total Prints
Level
Printer Status
Firmware Version
Print Status Sheet
PRODUCT DESCRIPTION
Table 1-15. Setup menu
Yes
No
Yes
No
-
-10 to +10 (default
values "1")
-1.00 to +1.00% (default
values "0.00")
On
Before Printing
White Ink
Off
Print
xxxxxx pages
Ink
Head Cleaning Set
xxxxxxx,x.xx,xxxx
Print
Operation panel specifications
If [Yes] is selected, mode can be switched from the current mode to other modes (High Speed
Color Mode is not available).

Using in White Ink Mode: switch to Color Ink Mode

Using in Color Ink Mode: switch to White Ink Mode
If White Ink Mode will not be used for more than 2 weeks, switch to Color Ink Mode to prevent
from quality deterioration of printing.
If this printer will not be used for more than a month, exchange ink with cleaning fluid to prevent
the quality deterioration. Prepare a cleaning cartridges and waste ink bottle before exchanging.
If the White Ink Mode will not be used for more than 2 weeks, use Replace White Ink instead of
this setting.
When the printed copy occurs granularity or out of focus, execute Head Alignment. Adjust the
misalignment of print head when printing by each size of Platen. Check the printed check pattern
visually. Calibrate by entering the Adjusting level that does not show fine lines. If there is no
optimum Adjusting level to the printed check pattern, enter "1" or "13" before executing this
setting again. When [Uni-Directional] is chosen by software or by configuration of this printer, it
does not effect on the printed copy.
Used for printing on T-shirts when printing sides are uneven (such as pockets) and can not adjust
Platen. Height adjustment lever lowers the level of Platen. In this state, Adjusting level should be
around "+3". Execute Head Alignment again not for the image to stir. This setting returns to
default level if undoing Head Alignment after having Offset Head Alignment done.
Adjusts the width (amount of sent Platen when print head moves one time). If fine deep-colored
lines are found, adjust towards "+". If fine light-colored lines are found, adjust towards "-".
Chosen only in White Ink Mode. The quality of printing may drop if cleaning has not been done
for a certain period for white ink. Sedimentation of ink component or nozzle clogging may be the
cause. ON: Executes cleaning after the power has been activated and initial movement is over.
Before printing: Executes cleaning when the power has been activated and before it starts
printing for the first time. Period of cleaning may differ according to how long the power had
been off. It may take for up to approximately 20 minutes.
Press [OK] to print history of printing.
Displays total of printing copies (up to 6 digits).
Displays each remaining ink. Exchange of ink cartridge will reset remaining ink automatically.
Displays the remaining amount of head cleaning set.
Displays firmware version of this printer.
Prints the list of set up state of this printer.
Each information can be checked collectively.
Revision C
Description
Confidential
24