Epson SC-F2000 Service Manual page 75

SC-F2000
3.4.3.4 PANEL ASSY
A D J U S T M E N T When replacing/removing this part, refer to
R E Q U I R E D
Items and the Order by Repaired Part" (p194)
perform the specified operations including required adjustment.
1. Open the PRINTER COVER.
2. Disengage the four hooks that secure the PANEL ASSY using a tool such as a
slotted-head screwdriver.
3. Disconnect the cable and FFC from the connectors of the board, and remove the
PANEL ASSY.
C H E C K
The printer cannot light the LCD based on old firmware which
P O I N T
dose not support 2.7 inches LCD when the switch is turned on after
inches LCD assembled. In this case, please update the firmware.
The new firmware which supports 2.7 inches LCD also supports 2.5
inches LCD.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
x
Disassembly and Assembly Procedure
PANEL ASSY
FFC
Hook
Connector
PANEL ASSY
Figure 3-18. Removing the PANEL ASSY
Revision C
Cable
Connector
75
Confidential