Shifting Lever With Engine At Stopping The Tractor - Manual Brake; Stopping The Engine; In Normal Operation Before You Leaving The Tractor - Zetor Major 80 Operator's Manual

STOPPING THE TRACTOR - MANUAL
BRAKE
Stop the tractor gradually in standard
conditions. Shortly before stopping:
1. Depress the clutch pedal.
2. Shift the main gear shifting lever to
neutral position.
3. With every stop over, secure the trac-
tor against spontaneous drive away
by a manual brake. Engagement of
manual brake is signalized by a lit
control on the dashboard.
DRIVING OPERATION
NM13N060

STOPPING THE ENGINE

After tractor's work when the engine was
properly loaded, its cool of must be en-
sured.
1. Before stopping the engine, lower the
revolutions to 800 - 1000 rpm and al-
low it to run without load for a time pe-
riod of about 5 minutes.
2. Shift manual fuel control lever to idle
run position
3. Hitch up a stopping g device and hold
it in hitched up position until there is
engine stop (push the control back in).
4. After stopping the engine, the key can
be shifted from position "I" to position
"0"
NM13N061
LEAVING THE TRACTOR
Before leaving the tractor with a safety
cab do not forget to remove the key from
the switch box in position "0" (only with
engine at standstill – charging control
must be on) and lock the cab. (The key
cannot be pulled out in positions I and II)
If the tractor is on the slope wheels must
be made stable with shims.
51
Tractor must be secured against
spontaneous drive away:
1. engine disengaged
st
2. 1 gear engaged
3. braked with the manual brake
NM13N062