Table of Contents
Advertisement
Stopping the tractor - manual brake
Stop the tractor slowly under standard conditions. Shortly
before stopping:
1. Depress the clutch pedal.
2. Shift the main gear shifting lever to neutral position.
3. With every stopping, secure the tractor against
spontaneous dead start by manual brake.
Stopping the engine
After the work of tractor when the engine was fully loaded,
it is necessary to secure its cooling.
1. Before stopping the engine, lower the revolutions to 800
- 1000 revolutions per minute and allow it to run for the
time of approximately 5 minutes.
2. Shift the lever of manual throttle to STOP position.
3. The engine stops after turning the key from 'I' position
to '0' position.
Attention! When the engine is switched off, the engine control unit remains active for about 2
minutes because of storage of operation data. During this time the supply of current from the
accumulator must not be interrupted. Do not disconnect the accumulator before this time expires.
Leaving the tractor
Before leaving the tractor with a safety cabin, do not forget
to remove the key from the switch box in '0' position (in
position 'I' and 'II' the key cannot be pulled out).
Tractor must be secured against spontaneous start:
1. Engine off
2. Braked by manual brake
3. Wheels based by wedges.
Engaging a speed gear does not secure the
tractor from start (clutch is switched off).
Lock the cabin.
DRIVING OPERATION
C18N085
C18N086
C18N087
121
Advertisement
Table of Contents
