Setting Wheel Stops With Front Drive Axle - Zetor MAJOR CL Operator's Manual

Setting wheel stops with front drive axle

Set the stops always with any wheel track change or tire
replacement with front drive axle.
Wheel stops with front drive axle must be set so that there
would be a distance of at least 50 mm between front drive
axle tires and tractor with full lock and full axle swing
around central pin.
Setting wheel stops with front drive axle check
1. Set full lock to one side and check that the distance
between a tire and the nearest solid point on the tractor is
at least 50 mm. Check both front tires.
2. Turn the steering to full lock to the other side and check
according to point 1.
3. Heave one side of the front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
4. Hoist the other side of front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
The setting of stops (A) changes after the release of a nut
(2) and unscrewing or screwing in a screw (1).
After the change in setting wheel stops with
front drive axle, it is always necessary to check their
setting according to points 1 to 4.
Front wheels toe-in
The value of toe-in of front wheels taken on the rim of
a tractor:
With driven axle 0 to 4 mm
'S' toe-in is given by the difference of measured values:
S = b - a.
Before checking toe-in, it is necessary to check
or adjust the clearance in front wheels bearings and
inflate front tires to prescribed pressure.
The measurement of toe-in is done on wheel rims.
WHEEL TRACK CHANGE
84
F13BN033
F_02_189