Setting Wheel Stops With Front Drive Axle; Setting Wheel Stops With Front Drive Axle Check - Zetor Major 80 Operator's Manual

SETTING WHEEL STOPS WITH FRONT DRIVE AXLE

Set the stops always with any wheel track change or tire replacement with front drive axle.
Wheel stops with front drive axle must be set so that there would be a distance of at least 50 mm between front drive axle tires
and tractor with full lock and full axle swing around central pin.

SETTING WHEEL STOPS WITH FRONT DRIVE AXLE CHECK

Set full lock to one side and check that the distance between a tire and the nearest solid point on the tractor is at least 50 mm.
Check both front tires. Turn the steering to full lock to the other side and check according to point 1.
Heave one side of the front axle to the maximum swing (front axle leans against the bracket) and check according to point 1
and 2.
Hoist the other side of front axle to the maximum swing (front axle leans against the bracket) and check according to point 1
and 2.
The setting of stops (A) changes after the release of a nut (2) and unscrewing or screwing in a screw (1).
After the change in setting wheel stops with front drive axle, it is always necessary to check their setting according to
points 1 to 4.
WHEEL TRACK CHANGE
F13BN033
89