Setting The Wheel Lock With Front Drive Axle; Wheel Lock Setting Inspection With Front Drive Axle - Zetor FORTERRA HSX 100 2014 Operator's Manual

SETTING THE WHEEL LOCK WITH FRONT DRIVE AXLE

Perform the setting of lock with every change of wheel track or tyre replacement with front drive axle.
The locks with front drive axle must be set so that the distance between the front drive axle tires and the tractor with full wheel
lock and full swing of axle around central pivot is at least 50 mm.

WHEEL LOCK SETTING INSPECTION WITH FRONT DRIVE AXLE

1. Set the full wheel lock to one side and check that the distance between a tire and the nearest stable point on the tractor is at
least 50 mm. Perform the inspection with both front tires.
2. Switch the steering to full wheel lock to the other side and perform the inspection according to article 1
3. Heave one side of front axle with a heaver to the maximum swing (the front drive axle is leaning against a console) and
perform the inspection according to articles 1 and 2.
4. Heave with a heaver the second side of the front axle to the maximum swing (the front axle is leaning against console) and
perform the inspection according to articles 1 and 2.
The setting of lock (A) changes after slackening the nut (2) and unscrewing or screwing in the screw (1).
After the change of wheel lock with front drive axle it is always necessary to perform the inspection of their setting
pursuant to articles 1 to 4.
WHEEL TRACK CHANGE
F13BN0033
157