Independent Pto; The Pto Monitor Lamp; Pto On / Off Switch; Pto Control Switch - Zetor HORTUS HS Series Operator's Manual

Independent PTO

It must be noted that the PTO shift lever on the LHS below
the driver seat should be shifted to position 1 (540 RPM)
0r 2 (750 RPM) depending upon the implement
specification.
In no case the specified speeds be crossed as serious
damage to the tractor / implement to person can result
because of this.
When the PTO is not in use the shift lever must be put in
neutral position to avoid unnecessary use or accidental
use.
1 - PTO ON/OFF button
2 - Key S/W
3 - PTO Mode S/W

The PTO Monitor Lamp

The PTO indicator light on the instrument panel indicates
the PTO status.
1. If the indicator light is on: PTO rotates.
2. If the indicator light is off: PTO is off.
3. If the indicator flashes: PTO is not currently in
motion, but shall be reactivated when the clutch
pedal is released or the implement is lowered to the
working position.

PTO On / Off Switch

Two switches control the independent PTO.
PTO ON / OFF Switch: The PTO ON / OFF switch is
located on the right side of the steering column and can
be easily identified by the built-in red indicator light.
When the switch is pushed down to engage the PTO, the
PTO indicator light comes on to indicate that the switch
and PTO are in the 'on'position. If the switch is pushed
down again, the indicator turns off to indicate that the PTO
is turned off.

PTO Control Switch

This switch is situated near the starting key location on the
dash panel. There are three positions marked for this
switch.
''Off'' at the center.

''Manual'' at the left.

''Auto'' at the right.

48
DESCRIPTION OF TRACTOR CONTROLS
HODP049
HODP050
HODP051
HODP052