(9)
When return spring is strong in force,
assemble 4 sets at the same time, utilizing
plate(31), and tighten joint(20) temporarily.
(10)
Fit plate(31).
(11)
Tighten joint(20) with the specified torque
to casing, utilizing jig.
(12)
Assemble plate(21) to joint(20).
Screw it to position that it contacts with 4
push rods evenly.
Do not screw it over.
(13)
Assemble adjusting nut(22), apply
spanner to width across flat of plate(21) to
fix it, and tighten adjusting nut to the
specified torque.
During tightening, do not change position
of disk.
7-101
RE37 (140-7)
RE38 (140-7)
RE39 (140-7)
RE40 (140-7)